MS Portable Cabin

The Multi-Storey Cabin uses mild steel framing throughout. A 100 mm × 50 mm I-beam forms the base - a 50 mm × 50 mm square tube caps the roof. Panels bolt to the frame - the unit assembles on site without cranes. A two coat epoxy primer and polyurethane topcoat repels rain, salt spray along with chemical vapour. 19 mm MS pipes brace each partition; 8 mm MDF OSL sheets line both faces - adding stiffness and thermal lag. Each floor carries a 250 kg/m² live load. Doors close flush, windows seal with EPDM gaskets, plus vents maintain airflow. The result shelters crews on multi level builds with minimal maintenance.

The MS Portable Cabins use 2 mm mild steel frames, zinc primed, powder coated white or yellow. Each 2.4 m × 6 m module ships as six bolt together panels - two fitters assemble the shell in ninety minutes. The 60 mm rock wool core cuts heat gain by 8 °C, keeps noise at 45 dB. A single door, two sliding windows, one exhaust fan along with four internal power sockets create a ready office. Fork-lift pockets and corner lifting eyes allow relocation by crane or truck. The paint layer resists salt spray for 500 hours - the frame tolerates 150 km/h wind.

Brand

Zion Cabins fabricates the Mild Steel Portable Cabin from 2 mm mild steel plate, seam welded to a 50 mm square tube frame. The rectangular shell splits into four bolted panels - two fit across a flat bed truck. A baked polyester coat in matte white with cobalt blue trim repels rain, salt spray along with UV. Each unit ships with a steel door, a sliding window in addition to a plywood floor rated at 250 kg per square metre. Total mass: 850 kg. Fork-lift pockets and four corner lifting eyes permit relocation by crane or loader. The cabin serves as site office, tool store, or break room - it assembles on level ground in twenty minutes with one wrench.

The Mild Steel Cabin shelters personnel on construction sites. High-grade mild steel plates form walls, roof and floor. A 100 mm × 50 mm I-beam undercarriage distributes loads across the chassis. Bolted tongue-and-groove panels interlock for rapid erection plus trap mineral wool between skins. Polyester powder coat repels rust and retains gloss after repeated washdowns. White or blue panels present a uniform façade. The cabin serves as site office, guard post or break room. Rectilinear lines, flush doors but also sealed joints withstand dust, rain and impact.

Zion Cabins fabricates the Steel Mild Cabin from 2 mm mild steel sheet. Each panel interlocks with the next through a tongue-and-groove seam - creating a monocoque shell that resists racking under wind loads of 120 km/h. A two coat epoxy primer and polyurethane topcoat shield the metal from salt spray but also UV exposure for a minimum of five years. A 100 mm × 50 mm I-beam undercarriage distributes point loads across a 12 mm chequered plate floor. The exterior arrives finished in RAL 9016 traffic white with RAL 5010 gentian blue trim. The cabin houses two workers or secures tools and documents at construction sites, quarries along with rail sidings.

Zion Cabins fabricates square MS Porta Cabins from 2 mm mild steel sheet, cold rolled, zinc coated, oven baked epoxy paint. Each wall panel locks into a 50 mm × 50 mm hollow section frame, welded, ground flush. The cabin measures 3 m × 3 m × 2.7 m - interior volume totals 24.3 m³. A single door, 2 m × 0.9 m, opens inward - two sliding windows, 1.2 m × 0.9 m, close with rubber gaskets. Fork pockets under the floor allow a forklift to lift the 1.8-tonne unit in minutes. The structure withstands wind at 120 km/h, resists salt spray for 500 hours.